MICROSCALE MICRO-2 MICRO SOL

MICROSCALE MICRO-2 MICRO SOL

Softener for decals

Vial of 29.5 ml (1 fl. oz.)

MI2 MICRO SOL is the solution for the application of decals in the most difficult places.

MI-2 is a softener for decals. The product completely softens the decal to allow it to stick perfectly to the surface of the support and this without the slightest distortion. So you can get a perfect result in places that seemed impossible. The decal seems to be part of the painting! ! ! You need to apply MICRO SOL for a few seconds and then let it act. Do not touch the decal during drying, you could cause irreparable damage.

For optimal results, first apply MICRO SET to prepare the surface and improve bonding. Make sure the surface is free of any particles that could damage the decal. Then when the decal is dry enough to stop moving, apply MICRO SOL with a soft and flat brush in the lightest possible way so as not to damage the decal. Let it dry. A single application will suffice in most cases, but if necessary, you can start the operation again after a complete drying until the desired effect is achieved. By following these few recommendations, you will get a job worthy of professionals!

Water cleaning