THOR15HF 16A 16v ESC

THOR15HF 16A 16v ESC

CTI THOR 15 HF

Electronic Speed Controller for brushed motors suitable for controlling downsized motors for slow propulsion (e.g. construction equipment)

New model with electromagnetic brake, low voltage detection and high operating frequency (18 Khz) to reduce motor whistling.

With forward/reverse

Voltage: 7.2v - 12 v. (6 to 10-cell Nimh or Lipo 2S or 3S batteries)

Internal control reduces motor speed to 25% if Lipo battery voltage falls below 6v (2S) or 9v (3S). The number of cells (2S or 3S) in the Lipo battery is automatically detected according to the voltage at start-up.

However, we recommend the use of a Lipo discharge alarm module for complete control (cell by cell) of the discharge of the Lipo battery in use.

Internal resistance: 25 milliohms.
Maximum current is 16 amps.

Silicone cables 1mm² without plugs are supplied for battery and motor connection.
Dimensions: 24 * 20 * 6 mm

French manual

Note for BEC system (receiver power supply):

BEC system for receiver and servos (max. power supply 9.6v, beyond this deactivate BEC)
The 5 V and 1A BEC function provides thermal and short-circuit protection.
(With a 6v power supply, BEC voltage is reduced)
When using several servos, the power of the BEC system may be exceeded, causing reception interruptions. In this case, deactivate the BEC by disconnecting the red wire from the cable linking the ESC to the receiver, then power the receiver with a dedicated "Ubec" module.