Masking fluid Tamiya 87229

Masking fluid Tamiya

Tamiya 87229

This liquid masking agent is ideal for masking curved surfaces and complex shapes to which masking tape does not adhere. It is easy to apply directly from the bottle, through the nozzle at the end of the bottle. It can be used for various acrylic paints (X, XF), enamels and lacquers (AS, TS, LP...), for both primer and topcoat, and the dried masking liquid can be easily recut with a cutter/scalpel.
Light green, water-based product.

Packaged in 20g bottles.

Instructions:

1. Degrease the surface to which the masking fluid is to be applied with a neutral detergent.
2. Apply directly from the bottle and allow to dry completely.
3. Using a cutter/scalpel, trim the area to be painted and remove any unnecessary parts before painting.
4. Remove the mask after the topcoat has dried completely.

Apply the masking fluid after the undercoat has dried completely.
Spread the masking fluid in a thin layer (it will dry in about 30 minutes). If you apply it in a thick layer, it will take longer to dry.
Use a new cutter/scalpel blade to cut the dried masking liquid. If cut edges float, hold them firmly before painting.
This product is water-soluble. When painting over water-soluble paints, take care not to dissolve them.
If applied to complex shapes, it may be difficult to remove after drying.
Take care not to squeeze the bottle too hard, as liquid may leak out.
If the nozzle becomes blocked, remove and clean it.