Switch for hydraulic pump brushless motor control 0H996

Switch for hydraulic pump brushless motor control

Leimbach 0H996

This module can be used when it is not possible to connect a controller (or RC relay system) directly to the receiver to control a hydraulic pump (for example, not enough channels available on the radio). If the model has a light module, then one can use 2 outputs of the light module to control the pump:
This module allows you to control a hydraulic pump brushless controller using a switch and a switching module rather than a proportional channel, to obtain 2 operating speeds.
It allows controlling the pump in 2 speed:
Position 1: approximate speed: 8000 rpm
Position 2: approximate speed: 12000 rpm

The speeds can be adjusted by two potentiometers on the board.

The module is controlled using a switching module type light module (CTI PS4, Robbe "Multi" module or MM4 Servonaut light module .)