Mini multi-switch module MM4 v2

Mini module multi-switch MM4

Servonaut MM4 v2

The MM4 has 4 control outputs and 2 outputs for servo.
The 4 control outputs allow for example the operation of lights, flashing lights, horns.

3 outputs are memory, (i.e. they are active until the stop order is given).

The fourth output can be configured (via a jumper) either in memory mode or impulse (which allows the headlight call function)

For easy connection to the power battery, use for example the accessories connection cords ACTM00015 or ACTM00013 (see "accessories" on this page)

Warning: the installation of LEDs involves the use of resistors!

Regarding servo outings:

Output n°1 works in all or nothing: the servo rotates slowly once from one extreme position to another (amplitude of 90 °). This is useful for, for example, controlling the door opening or the tilting of ramps.
On exit 2, the servo continuously rotates from one side to the other. This is useful, for example, for, the control of wipers.

This module requires a free channel on the radio (proportional channel or a 3-position switch)

Technical specifications:

• Operating voltage of the outputs: 4.8v to 18v
• Voltage at reception level: 4.8v to 6v
• Functions: 3 memory outputs, one output to choose from (memory or momentary)
• Maximum current per output: 700mA
• servo outputs: one in wiper mode (sweep), one in actuator mode (all or nothing)
• Standby consumption: 22mA under 6v
• Control: proportionally or switch 3 positions.
• Connector to receiver: UNI (universal) type / Graupner /JR
• Power connector: male spout type
• Dimensions: approx 45x22x12mm

Required material not included (available separately, see "accessories")

• Battery connection cord

Notice in French (translation made by TECNIMODEL).