Screw actuator for lifting system

Delivered without motor (see "accessories" for a suitable geared motor)

Screw cylinder used on the Carson bucket lifting system. (Can also be used for the motorization of Goldhofer trailer ramps)

Although the installation of an end-of-stroke system is preferable, this system can work without an end of stroke: at the end of the stroke, the nut comes out of the thread so as not to block and a return spring allows the nut to be re-engaged on the screw for the return movement.

Tip for fixing an engine shaft of diameter Ø5mm (engine not delivered, see "accessories")

Screw clamping of the motor shaft

The length dimensions are given from the axis of the fixing eye to the end of the tip on the motor side.

Retracted length: 135mm

Extended length: 228mm (i.e. a stroke of 93mm)

Thread Ø10mm not thin (not 1mm)

Body diameter: Ø14mm

Maximum outer diameter: Ø19mm

Maximum outer width: 22.5mm

Diameter of the fixing eye at the end of the cylinder: Ø6mm