Thor 4 HF Titan 2 Control Module

CTI TITAN 2

NOT SUITABLE FOR VERINS TITAN SX

The THOR 4 HF Titan 2 actuator controller allows the control of 2 Titan electric cylinders installed in parallel.

It works on the principle of measuring the consumption of the cylinder and ensures the engine stop when the cylinder is at the end of the stroke, by detecting the increase in consumption at this moment.

This module is designed exclusively for the control of two Titan cylinders mechanically mounted in double (e.g. lifting a loader arm).

Power supply: Lipo Battery 3S (11.1v) or Nimh 10 elements (12v)

BEC system: The THOR 4 HF Titan has a BEC power supply for the receiver (5v output). However, it should not be used to power servo motors as this could affect the current measurement of the module and interfere with the operation of the cylinder. In this case, disconnect the red wire that connects the module to the receiver.

Warranty: 6 months warranty - Do not shorten wires by less than 8 cm.

Protect the module from dust, dirt and moisture.

Any use other than for a Titan electric cylinder, in the context of modeling, is prohibited and voids the warranty.

Connection: Connect the yellow wire of the controller to the yellow wire of the cylinder and the blue wire of the controller to the blue wire of the cylinder.

Connect the red wire to the "plus" of the battery and the black wire to the "minus" of the battery.

Connect the three-wire cord (yellow/red/brown) to the receiver.

Preferably disconnect the red wire that connects the module to the receiver.