Servonaut E22 Speed Controller for radio-controlled trucks.

Servonaut E22 Speed Controller for radio-controlled trucks.

Servonaut E22

With cruise control, 5v/3A spout, brake and reversing lights and low-voltage control.

Electronic speed controller for conventional (brushed) motors, specially designed for radio-controlled trucks.

With cruise control, 5v/3A BEC output, brake and reverse lights and low-voltage control.

The E22 offers the traditional operation of a Servonaut ESC with a speed regulator ("Tempomat") that ensures a smooth, smooth ride and very fine maneuvering. Its operation simulates the acceleration and braking of a heavy vehicle, avoiding sudden starts and stops. Its high operating frequency avoids the hissing noise found on many other brands of inverter. Its powerful electromagnetic brake keeps you in control, even when braking downhill. Diagnostic LEDs indicate any potential problems. The E22 has two outputs for brake and reversing lights. It is protected against overvoltage, overload, low voltage and excessive temperature. Its 5v BEC circuit can power several servos of standard size and power.

Pushing the stick forward causes the model to accelerate; returning to neutral has no effect, and the model continues to move at continuous speed (cruise control mode).

Pushing the stick forward causes acceleration.

Pulling back on the stick causes deceleration. Emergency braking is achieved by rapidly pulling back the stick to the bottom, at which point the stop lights come on.

The ESC features an electromagnetic brake, keeping the model under control and preventing it from accelerating on its own on a slope.

We recommend using a stick with neutral return (spring-loaded, without detent)
Reverse gear is activated by pulling the stick down and then to the left. Forward gear is activated by pulling the stick down and then to the right. When reverse gear is engaged, the lights and reversing alarm are activated, even when the vehicle is stationary, as in the real world.

Motor consumption, battery voltage level, transmission signal quality and module radiator heat are constantly monitored. If a fault is detected, the motor is slowed down and stopped.

Note: With this ESC, son Servonaut modules have no recoil beep.

Specifications:

• Operating voltage: 7.2 ... 12 V NC / NiMH or 2s ... 3s Li-Ion/Lipo
• Output: 20A / 5 min (30A / 30s)
• Frequency: 16 kHz
• BEC: 5V / 3A peak
• Outputs for brake and reversing lights: 2 x 700mA
• Control output: 1 for sound module Servonaut
• Dimensions: 70 x 36 x 8mm
• Powerful electromagnetic brake
• Regenerative braking: during braking, the energy recovered recharges the battery.
• Protection against overheating and current peaks
• Low voltage detection.
• Protection against signal loss.
• Requires 2 channels
• French manual by Tecnimodel