Control module for 2 TITAN SX cylinders

For 2 TITAN SX cylinders SICON

The THOR TITAN SX 2 actuator controller allows you to control two TITAN SX electric cylinders, mounted in parallel, proportionally from a radio controller.
The THOR TITAN SX 2 cylinder controller operates on the principle of measuring the consumption of the cylinders and ensures the engine shutdown when the cylinders are at the end of the stroke, by detecting the increase in consumption at this moment.
This module is designed exclusively for the control of two TITAN SX electric cylinders installed in parallel, with a 12v (10 Nimh elements) or 11.1v (Lipo 3S) power supply

Feeding:

Lipo Battery 3S (11.1v) or Nimh 10 elements (12v)

BEC system:

The THOR TITAN SX 2 has a BEC power supply for the receiver (output 5v). However, it should not be used to power servo motors as this could affect the current measurement of the module and interfere with the operation of the cylinder. In this case, disconnect the red wire that connects the module to the receiver.


Any use other than for two TITAN SX electric cylinders, as part of the modeling, is prohibited and voids the warranty.

Connection:

Connect the yellow wire of the controller to the yellow wire of the cylinder and the blue wire of the controller to the blue wire of the cylinder.

Connect the red wire to the "plus" of the battery and the black wire to the "minus" of the battery.
Connect the three-wire cord (yellow/red/brown) to the receiver.

Preferably disconnect the red wire that connects the module to the receiver.